[ Pobierz całość w formacie PDF ]
.(see Installation )." The free end of the hose is under water (see Installation )." The wall drainage system is not fitted with a breather pipe.If the problem persists even after these checks, turn off the water tap, switchthe appliance off and contact the Assistance Service.If the dwelling is on one ofthe upper floors of a building, there may be problems relating to water drainage,causing the washing machine to fill with water and drain continuously.Specialanti-draining valves are available in shops and help to avoid this inconvenience.The washing machine does not" The wash cycle does not include draining: some wash cycles require the draindrain or spin.phase to be started manually." The drain hose is bent (see Installation )." The drainage duct is clogged.The washing machine vibrates a lot" The drum was not unlocked correctly during installation (see Installation ).during the spin cycle." The washing machine is not level (see Installation )." The washing machine is trapped between cabinets and walls (see Installation ).The washing machine leaks." The water inlet hose is not screwed on properly (see Installation )." The detergent dispenser drawer is blocked (for cleaning instructions, see Careand maintenance )." The drain hose is not fixed properly (see Installation ).The function indicator lights and" Switch off the machine and unplug it, wait for approximately 1 minute and thenthe start/pause indicator light flash,switch it back on again.while one of the phase in progress If the problem persists, contact the Technical Assistance Service.indicator lights and the door locked indicator light will remain lit in a fixedmanner.There is too much foam." The detergent is not suitable for machine washing (it should display the text for washing machines or hand and machine wash , or the like)." Too much detergent was used.23 Service195110446.0111/2013 - Xerox FabrianoBefore calling for Assistance:GB" Check whether you can solve the problem alone (see Troubleshooting );" Restart the programme to check whether the problem has been solved;" If this is not the case, contact an authorised Technical Assistance Centre using the telephone number provided on theguarantee certificate.! Always request the assistance of authorised technicians.Have the following information to hand:" the type of problem;" the appliance model (Mod.);" the serial number (S/N).This information can be found on the data plate applied to the rear of the washing machine, and can also be found on thefront of the appliance by opening the door.24
[ Pobierz całość w formacie PDF ]